Going Beyond the Energy Audit to Achieve Deep Carbon Reductions

In collaboration with the Association of Energy Engineers, Prism shared notes on the differences between energy audits and deep carbon reduction studies, practical challenges of deep carbon retrofits and a case study for the City of Vancouver Kitsilano Community Centre.

Mechanical Systems for a Better Climate

Presented at the 2019 Housing Central Conference, this session outlines sustainability in BC, energy basics and provides a mechanical systems overview for typical multi-unit residential residential buildings. Energy and carbon saving opportunities are also shared including ones for fan systems, heating, domestic hot water, and cooling.

Adaptation Towards Low Carbon Resiliency in Buildings

This webinar was hosted by Prism Engineering to:

  • Discuss why adaptation is important
  • Define low carbon resiliency
  • Advise where to start
  • Find a framework that suits you
  • Share case studies of past projects
  • Provide ideas on how we can help

Monitoring, Targeting & Reporting in Buildings

Monitoring and targeting (M&T) energy use is a critical component of an effective energy management program. M&T techniques provide energy managers and users with feedback on operating
practices, results of energy management projects and guidance on the level of energy use that is expected in a certain period.

Economizers for Air Conditioning Units

Individually packaged heating, ventilating and air-conditioning (HVAC) systems, usually placed on the roof and known as rooftop units (RTUs) , are widely used in small and medium-sized commercial and institutional buildings.

Premium Efficiency Motors

Electric motor systems consume large amounts of electrical energy and can provide an opportunity for significant energy savings.

Heat Recovery with Boiler Stack Economizers

A stack economizer is a water-to-air heat exchanger that is designed to use heat from hot boiler flue gases to preheat water. For many decades, economizers have been used on large utility steam boilers to preheat the feedwater using recovered stack heat.

The same principle can be applied to smaller hydronic heating boilers where there is a nearby demand for hot water. These installations have become more economical as energy prices have risen and smaller economizers with light but durable and efficient heat exchangers have been developed.

Lighting Control

One of the simplest ways to conserve energy is to turn lighting systems off in unoccupied areas.

However, accomplishing this task can sometimes be a challenge. Building lighting can be controlled by many methods, from simple – local switches, occupancy sensors, photocells and time clocks – to more elaborate computerized lighting control systems which can be tied in to automatic building mechanical and security system controls.

This fact sheet discusses the various control types and their operation and application.

Heat Recovery from Kitchen Refrigeration

Commercial kitchens require walk-in refrigerators and freezers to store perishable food. Each unit is normally equipped with its own compressor/condenser package which is cooled to remove the heat generated by the vapour compression refrigeration cycle.

Typically, this heat is released into the environment. Where the equipment is water-cooled, that heat can be recaptured for useful purposes like domestic water heating.

Reducing Water Use by Installing a Closed-Loop Compressor Cooling System

Some water-cooled air compressors use domestic cold water to cool the air between compression stages, and sometimes after the final compression stage. In urban areas, using cold municipal water for cooling purposes in an open loop (in which water passes through only once) is costly and wasteful.

This type of cooling is common in many systems because it is simple to set up and cold water is readily available. However, installing a closed-loop fan-coil system can nearly eliminate domestic water usage during winter and shoulder seasons.